VAL Avionics NAV 2000 Installationsanleitung PDF herunterladen (Seite 242)

SV-ARINC-429 Installation and Configuration

12-2 SkyView System Installation Guide - Revision R

Additional mounting location, orientation, and other installation requirements are described in

the System Planning section earlier in this manual. Please review this section when physically

installing your with SV-ARINC-429 module(s).

Dynon does not provide mounting hardware with SV-ARINC-429 module. The mounting tabs on

each side of the module have holes sized for #10 fasteners, but it is up to the installer to decide

how the SV-ARINC-429 will be secured to the aircraft.

Follow recommended torque practices when tightening the mounting hardware. Do not rivet

the SV-ARINC-429 to the aircraft as this will hinder future removal if necessary.

SkyView Network Connection

Connect the SV-ARINC-429 module to the SkyView network using the hardware mentioned in

the SkyView System Construction Section or using equivalent hardware.

If you have to install a connector on the end of a network cable, insert all pins into the D9

connector. Refer to Appendix C: Wiring and Electrical Connections for details on connector pin-

outs and wire colors.

Remember to configure the network as described in the Network Setup and Status

section after connecting all modules to a display.

ARINC-429 Device Connection

Harness Construction

Because the SV-ARINC-429 can be connected to a variety of devices, the harness requirements

will vary from airplane to airplane. Therefore, Dynon Avionics does not supply pre-

manufactured harnesses for the SV-ARINC-429 module. Instead, your SV-ARINC-429 shipped

with enough connectors and pins to generate a wide variety of harness configurations. Refer to

the sections below for detailed wiring information.

If you do not own a D-sub machined-pin crimping tool, they can be obtained for under $50 from

many retailers. See http://wiki.dynonavionics.com/Tools_not_supplied_by_Dynon for known

sources of these products. You may also find it helpful to own a pin insertion/extraction tool as

well.

Additional harness construction and wiring information can be found in Appendix C: Wiring and

Electrical Connections.

The SV-ARINC-429 has a single 25 pin female D-Sub socket which is used for all data

connections to your compatible ARINC-429 device. The pin out depicted in Figure 81 below

depicts the view from the rear of your male D25 connector – the view you will have of your

harness connector as you are inserting pins into the harness. Note that the pin numbers are

labelled on the face of both the female and male connector.

1 2 ... 237 238 239 240 241 242 243 244 245 246 247 ... 400 401

Keine Kommentare

VAL Avionics NAV 2000 Installationsanleitung Seite 242