VAL Avionics NAV 2000 Installationsanleitung PDF herunterladen (Seite 238)

SV-XPNDR-261/262 Installation, Configuration, and Testing

11-20 SkyView System Installation Guide - Revision R

Note that after the transponder version 2.02 transponder update, only the SV-XPNDR-261 is

capable of meeting the 2020 ADS-B Out mandate, because of power transmission requirements

that the FAA ADS-B rules imposes. In other words, the SV-XPNDR-262, even if it is updated to

this software, cannot be used for 2020 ADS-B Out compliance credit.

SkyView v10.0 Transponder Software Version (SW) 2.04 Update

The optional transponder software (SW) version 2.04 software update that is contained within

SkyView software v10.0 and later fixes an issue that only pertains to some installations. It also

includes the updates described above for transponder firmware version 2.02 update. If either

of the following scenarios describes your installation, you should update your transponder to

version 2.04 software:

 If you have a Garmin GNS, GTN or similar IFR GPS that is directly connected to the

transponder to provide a certified position source via Garmin’s ADS-B format data output,

you MUST update to version 2.04 or later.

 If you are in the US and are using a Dynon transponder plus SV-ADSB-470 module to receive

both traffic and weather AND your transponder software version is a lower number than

2.02, you should update to version 2.04 to update so that it meets the latest TSO C166b. If

your transponder is not updated to the latest TSO, you will not receive a complete traffic

portrait. This applies whether or not you are using a TSO’d GPS or SkyView as your ADS-B

position source.

If your transponder has not been previously updated (such as if you are updating to SkyView

software v10.0 from a SkyView software version that is earlier than v5.0, applying the

transponder version 2.04 update will update your transponder to the latest software (it is not

necessary to apply version 2.02, and then version 2.04). If you are updating your transponder

for the first time, to version 2.04, the labeling requirements below apply.

Transponder Software Version (SW) v2.02/v2.04 Labeling Requirements

(US Registered / Operated Aircraft Only)

This section applies to aircraft operated or registered in the US only.

In the US, updating your transponder software to SW version (minimally) v2.02 REQUIRES that

the physical transponder module be labeled to indicate the new TSO authorization. Failure to

perform this physical modification at the same time as the software update will result in a

transponder that is not considered airworthy by the FAA. If updating from a version earlier than

v2.02 to v2.04, the label must be applied. If your transponder shipped with either v2.02 or

v2.04 it will already have the correct label.

Applicability/Compliance

If your transponder shipped from Dynon Avionics after September 2012, it likely shipped with

software version 2.02 (or higher) and is already labeled with its TSO C166b appropriately.

However, this is not authoritative.

1 2 ... 233 234 235 236 237 238 239 240 241 242 243 ... 400 401

Keine Kommentare

VAL Avionics NAV 2000 Installationsanleitung Seite 238