VAL Avionics NAV 2000 Installationsanleitung PDF herunterladen (Seite 11)

SkyView System Installation Guide - Revision R xi

Revision

Revision Date

Description

Sensor definition files do not match between SkyView displays (Page 7-60)

Transponder HEX CODE is not set (Page 11-15)

 Wide field of view for Synthetic Vision (Page 3-12)

 Vne can now be expressed as TAS as well as IAS (Page 5-8, 10-20)

 MW Fly AEROPOWER engines supported in SV-EMS-221 (Page 7-1)

 AP Disconnect/CWS Switch and External LEVEL Button status is checked at boot.

(Page 10-13, 10-14)

 AP Disconnect/CWS Switch is checked upon entering SERVO CALIBRATION (Page 10-

16)

 ADS-B traffic display enabled with non-Dynon ADS-B OUT devices (Page 14-1)

 Independent volume control for Angle of Attack (Page 15-7)

Documentation added:

 Added explanation that SkyView can be powered on during engine start (Page 2-5)

 Recommendation to install Panel Mount USB cable with each SkyView display (Page

2-6)

 Serial port connection and configuration information for Emergency Location

Transmitter (ELT) (Page 4-20)

 External Dim Control Connections (Page 4-20)

 SV-ADAHRS-200/201 must be installed level or the Slip/Skid Ball will not be centered

(Page 5-3)

 Caution about applying too much torque when installing SV-BAT-320 (Page 9-2)

 Addition of capacitor to servo to eliminate Intercom noise (Page 10-12, 10-13)

 Pin descriptions, added wiring diagram for SV-AP-PANEL Trim Controller installation

(Chapter 19)

 As of v11.0, SkyView does not have “Auto Trim” capability (Page 19-3)

 Alert Data Log (Page 26-2)

Documentation improved:

 Getting Started (Pages 1-2 through 1-4)

 SkyView System Power Specifications (Table 2, Page 2-2)

 Corrected SV-XPNDR-261/262 dimensions (Page 2-3)

 Recommendation to not use stainless steel hardware for installing SV-ADAHRS-

200/201, added recommendation to use Brass hardware (Page 2-8, Page 5-3)

 Explanation of Dynon Diagnostic File (Page 3-10 and Page 3-16)

 Updated screen shots throughout SV-D700 / SV-D1000 / SV-D1000T Installation and

Configuration (Chapter 4)

 Moved configuration information for Garmin GTX 330ES to Traffic Devices section

(Page 4-14)

 VAL NAV 2000 – frequency cannot be displayed on top bar (Page 4-17)

 Updated SV-ADAHRS-200/201 Magnetic Calibration Procedure (Page 5-5)

 Differences between SV-EMS-220 and SV-EMS-221 (Page 7-1)

 Rotax oil pressure sensor connector charge (Page 7-41, 7-42)

 Oil temperature sensor section, updated crush washer installation instructions.

(Page 7-42)

 Rotax 914 Differential Fuel Pressure Sensor UMA N1EU07D guidance improved

(Page -7-44, 7-45)

 Suppress units displayed on sensor widgets (Page 7-63)

 Effect of setting ALLOW AUTO SWITCH to YES (LABEL 100P) for 430/530 (Page 12-7)

and GTN-series (12-9)

 Setup for transponders other than SV-XPNDR-261/262 with ADS-B OUT for receiving

ADS-B Traffic information with SV-ADSB-470 (Page 14-1)

 Check for blockage of AOA / Pitot lines prior to installation (Page 15-10)

 SV-COM-C25 Post Installation Checks, Continued Airworthiness and Maintenance

(Page 16-8, 16-9)

 Homemade Wire Harness Considerations (Page 21-2 through 21-4)

 MAP button no longer available (Page 21-11)

 Kavlico pressure sensors information (Appendix G)

Table 1–SkyView System Installation Guide Revision History

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 400 401

Kommentare zu diesen Handbüchern

Keine Kommentare

VAL Avionics NAV 2000 Installationsanleitung Seite 11

Kommentare zu diesen Handbüchern