VAL Avionics NAV 2000 Installationsanleitung PDF herunterladen (Seite 192)

SV-BAT-320 Installation

9-4 SkyView System Installation Guide - Revision R

Detailed Battery Status Check

Enter the Display Hardware Information Page (SETUP MENU > LOCAL DISPLAY SETUP > BATTERY

BACKUP (SV-BAT-320) STATUS to check the status of the battery.

 BATTERY CONNECTED (BATTERY DETECTED): YES / NO

o SkyView automatically sets this to yes when a battery is installed.

 LAST BATTERY SHUTDOWN:

o NORMAL

o ABNORMAL: The last shutdown of SkyView did not happen normally.

o WEAK BATTERY: SkyView detected a low battery voltage condition when SkyView

was last shut down. The battery may be discharged or may need replacement.

SkyView will annunciate a warning if this happens repeatedly.

 DATE OF LAST TEST: UNTESTED / MM-DD-YYYY

o If this date is over a year ago, SkyView will annunciate BATTERY TEST NEEDED upon

startup. Follow the steps in the Initial / Recurrent Backup Battery Test section below.

 TEST RESULT:

o FAIL: VOLTAGE DROP TOO HIGH: Battery likely needs to be replaced. Contact Dynon

Technical Support (contact information at the beginning of this manual).

o FAIL: LASTED xx MINS: Battery likely needs to be replaced. Contact Dynon Technical

Support (contact information at the beginning of this manual).

o PASS BATT LIFE > 45 MIN: The last full test of battery passed

 BATTERY STATUS: (voltage)

 CHARGE STATUS: CHARGING/DISCHARGED/CHARGED/STANDBY/NO BATTERY

An SV-BAT-320 is fully charged when it reaches 12.25 volts. Charging a completely

discharged battery may take up to 4 hours. To conserve your aircraft battery, the

SV-BAT-320 only charges when SkyView detects that your alternator or generator

is running (whenever your engine is running), which is when SkyView’s input

voltage is above 12.25V. Alternatively, connecting a battery charger to your

aircraft battery will also raise the input voltage to a level that will allow SkyView’s

SV-BAT-320 to charge.

The SV-BAT-320 must only be charged by SkyView. External charging of the battery

is not supported. External charging of the battery can damage it or cause it to

explode.

Initial/Recurrent Backup Battery Test

Perform this test to ensure each backup battery in the SkyView system is fully functional upon

initial installation and yearly thereafter. SkyView records the date of the last battery test and

will annunciate, both via a message and by the “needs test” icon in the top bar, when a year has

passed since the last successful battery test.

A fully charged SV-BAT-320 should power a SkyView system for at least 60 minutes if primary

power is lost. As your backup battery ages, the length of time that it can keep a SkyView display

1 2 ... 187 188 189 190 191 192 193 194 195 196 197 ... 400 401

Keine Kommentare

VAL Avionics NAV 2000 Installationsanleitung Seite 192